|
|
|
|
Description:
|
adjacencyStateChange NOTIFICATION
BEHAVIOUR adjacencyStateChange-B BEHAVIOUR
DEFINED AS The Adjacency State Change Notification is generated when the state of an Adjacency on the Circuit changes from Up to Down or Down to Up (in the latter case the Reason argument is omitted). For these purposes the states Up and Up/dormant are considered to be Up, and any other state is considered to be Down. The relative order of
events relating to the same Adjacency must be preserved. The occurance of this event is counted by the adjacencyStateChanges counter.;;
MODE NON-CONFIRMED;
PARAMETERS
notificationAdjacentSystem,
notificationNewAdjacencyState,
notificationReason,
notificationPDUHeader,
notificationCalledAddress,
notificationVersion;
WITH INFORMATION SYNTAX NotificationInfo;
|
|
Information:
|
Automatically extracted from IETF RFC 1142.
Note: According to IETF RFC 7142, RFC 1142 was a republication of ISO Draft Proposal (DP) 10589 but differed in a considerable number of significant respects from the final standardized version published as ISO/IEC 10589:2002.
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved © 2007-2024 |
joint-iso-itu-t(2)
