|
|
Description:
|
docsLeakDetTestSessionStatusStatus OBJECT-TYPE
SYNTAX INTEGER {pending(0), active(1), cancelled(2), completed(3)}
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"This attribute reports the status of the Leakage Detection Test Session
identified by the corresponding Session Id.
- pending(0) indicates the Leakage Detection Test Session has been
configured but has not started because the configured
StartTime has not occurred yet or the CCAP is in the
process of scheduling Leakage Detection Testing Bursts
for the configured set of Test Cable Modems.
- active(1) indicate the Leakage Detection Test Session has started,
i.e., the CCAP is issuing grants to Test Modems, and the
Session has not completed yet. Once a session becomes active
and until the session is explicitly cancelled or completes
i.e., reaches StopTime, it will remain active. This is true
even if there are no modems currently being granted bursts.
- cancelled(2) indicates the Leakage Detection Test Session had been
initiated but was stopped by the Leakage Detection Test
Interface Application.
- completed(3) indicates the Leakage Detection Test Session ran and
stopped at the configured StopTime."
REFERENCE
"Information Model Mapping: CM-SP-CCAP-OSSI
LeakageDetectionTestSessionStatus::Status"
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved, Orange © 2024 |